gfjfghfjfh V1.3 MMDVM_HS_Dual_Hat Hotspot Duplex Prise en Charge d’antennes OLED P25 DMR YSF NXDN Module Assemble Board Raffiné

Modèle: 00019887


Économie : 45% de remise
Features: - High performance 32-bit ARM processor- Fully tested- Supports DMR. P-25.D-Star and System Fusion- Onboard LEDs to show status (Tx.Rx.PTT.Mode)- Up to 10mW RF power- SMA antenna connector.Antenna included- Mounts cleanly on all current Raspberry Pi's including the Pi Zero- The firmware is pre-loaded and is easily upgraded via software.- Open source 3D printable case available- UHF 430-450 MHz.433mhz and 900MHzSpecifications:The upper part is TX.the lower is RX antenna.UHF VHFSMA.antennaModem select:STM32_HS_GPIOSet TX frequency.RX frequencyTX.RX frequency had better 10M or more apart.SLOT1.SLOT2 support.Package List:Assembled item including the below parts - MMDVM duplex HotSPOT Module x1- Antenna x 2- oled x1 Note:1.Due to the difference between different monitors. the picture may not reflect the actual color of the item. We guarantee the style is the same as shown in the pictures.2.Due to the manual measurement and different measurement methods. please allow 1-3cm deviation. Thanks!
- Processeur ARM 32 bits hautes performances
- Entièrement testé
- Prise en charge de DMR. P-25. D-Star et System Fusion
- LED intégrées pour indiquer l'état (Tx. Rx. PTT. Mode)
- Puissance RF jusqu'à 10mW